How to use Morplan's QuickTag Mk3 tagging gun

This ‘how to’ specifically covers our QuickTag Mk3 tagging gun, which uses a MK2 needle but could also be applicable as a rough guide for other brands and gauges.

Choosing the correct attachment

First things first, it is important to note that standard gauge guns can only be used with standard gauge attachments, and the same is true for fine gauge guns.

Read our blog ‘How to choose your tagging gun and attachments’ for more guidance on what to consider when making your selection.

Inserting the attachments and using the tagging gun

Thread the ‘T’ end of the attachment strip into the T shaped slot at the top of the gun.

To start using the gun, first remove the safety cover over the needle, then hold the needle tip gently against the item you wish to tag and pull the trigger, this will cause the attachment to fire through the needle.

Once all the attachments are gone, the empty strip will drop out of the bottom of the gun.

If you need to remove a half-used strip, pull back the latch on the top of the gun to release the strip and lift it out.

Troubleshooting potential problems:

Will I need to replace the needle?

MK2 tagging gun needles have an integral blade that may become blunt over time and requires replacing

What do I do if the guns jams?

If the gun becomes jammed, do not force it to fire, as the pin that goes through the needle to push the attachments through is delicate and if it gets bent, it cannot be repaired. To fix the a jammed tagging gun, remove the tags and the needle, and then reset.

Changing the needle:

To release the needle, turn the needle stay clockwise so it points towards the needle tip. Being aware of the sharp end, slide the old needle out.
To insert the new needle, simple slide it in, ensuring the notch is at the top and the groove is facing you.
Lock it into position by turning the needle stay anticlockwise as far as it will go.
Check the needle is secure by holding the shaft of the needle and gently tugging.
If the needle stay doesn't go back easily, check your alignment and try again.

A guide to using different attachment types

Securing tickets:

Slide the label down the needle, with the design facing the gun. Then hold the needle against the clothing you are attaching it to and pull the trigger.

securing two clothing items together_tagging guns

Linking sets of items:

Press the needle gently in the place on both items where you would like to attach them, pull the trigger to fire through both items.

Display sets with minimalist style display fittings such as euro hooks on Slatwall fittings by using hook attachments on your linked items.

securing clothing to hangers_tagging guns

Secure to a hanger:

Choose a hanger with the appropriate functions that allow attachments, secure the item by lining the item and the needle up with the hole and pull the trigger.